Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
268
Views
0
Helpful
1
Replies

Manage cluster member ports from cluster cmd on 2960?

Brian M
Level 1
Level 1

‎06-03-2008 01:03 PM - edited ‎03-05-2019 11:24 PM

Is it possible to manage the ports of my cluster members from the CLI on the commander? I would like to have a setup similar to that of the 3750 stack where switch one is gig0/1 and switch two is gig1/1 ...etc

I have clustering configured but when I do a sho ver I only see one switch in my list.

Thanks!!

Labels:
0 Helpful
1 Reply 1

ebreniz
Level 6
Level 6

‎06-09-2008 12:07 PM

The following URL will help you

Configuring a Management Interface for 2900/3500 XL Switches :

http://www.cisco.com/en/US/products/hw/switches/ps700/products_tech_note09186a008010e9ca.shtml

Configuring the Basic Switch Information :

http://www.cisco.com/en/US/docs/switches/lan/catalyst2900xl_3500xl/release12.0_5_wc_1_/swg/swgsyst.html

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents
Review Cisco Networking products for a $25 gift card