DO you know what is this error message?
.Jun 3 00:42:27.304 GMT: %HSRP-6-STATECHANGE: GigabitEthernet0/1.2 Grp 2 state Active -> Speak
.Jun 3 01:06:46.446 GMT: %HSRP-6-STATECHANGE: GigabitEthernet0/2.22 Grp 34 state Standby -> Active
.Jun 3 01:06:46.522 GMT: %HSRP-6-STATECHANGE: GigabitEthernet0/1.2 Grp 2 state Standby -> Active
.Jun 3 01:06:50.634 GMT: %HSRP-6-STATECHANGE: GigabitEthernet0/2.22 Grp 34 state Active -> Speak
I found quite a number of this in the router..
Is this normal?
As per cisco there is no action required for this error.
If still theres problems in the network you may need to do some troubleshooting.
These error messages describe a situation in which a standby HSRP router did not receive three successive HSRP hello packets from its HSRP peer. The output shows that the standby router moves from the standby state to the active state. Shortly thereafter, the router returns to the standby state. Unless this error message occurs during the initial installation, an HSRP issue probably does not cause the error message. The error messages signify the loss of HSRP hellos between the peers. When you troubleshoot this issue, you must verify the communication between the HSRP peers. A random, momentary loss of data communication between the peers is the most common problem that results in these messages. HSRP state changes are often due to High CPU Utilization. If the error message is due to high CPU utilization, put a sniffer on the network and the trace the system that causes the high CPU utilization.
There are several possible causes for the loss of HSRP packets between the peers. The most common problems are physical layer problems or excessive network traffic caused by spanning tree issues. As with Case Study #1, all the troubleshooting modules are applicable to the resolution of HSRP state changes, particularly the Layer 3 HSRP Debugging.
below is the link.
Hope this helps.