06-04-2008 01:31 AM - edited 03-15-2019 11:03 AM
Hi
I have a CCME with E1 card (PRI).
All incoming calls are showing as "external Unknown Number" is there any way to enable this? or it to do with the teleco NOT sending the numbers????
your help is much appreciated
thanks
06-04-2008 05:07 AM
What is IOS version running on the Router. Could be the Bug ID: CSCsh45544.
Basant
06-04-2008 04:41 PM
Hi Basant,
see below
show ver
Cisco IOS Software, 2800 Software (C2800NM-ADVENTERPRISEK9-M), Version 12.4(11)XW5, RELEASE SOFTWARE (fc1)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2007 by Cisco Systems, Inc.
Compiled Sat 17-Nov-07 10:08 by prod_rel_team
ROM: System Bootstrap, Version 12.4(13r)T, RELEASE SOFTWARE (fc1)
SX-BROOME-CCME uptime is 37 minutes
System returned to ROM by bus error at PC 0x42E92170, address 0x20494B45 at 07:59:01 WST Thu Jun 5 2008
System restarted at 08:00:53 WST Thu Jun 5 2008
System image file is "flash:c2800nm-adventerprisek9-mz.124-11.XW5.bin"
This product contains cryptographic features and is subject to United
States and local country laws governing import, export, transfer and
use. Delivery of Cisco cryptographic products does not imply
third-party authority to import, export, distribute or use encryption.
Importers, exporters, distributors and users are responsible for
compliance with U.S. and local country laws. By using this product you
agree to comply with applicable laws and regulations. If you are unable
to comply with U.S. and local laws, return this product immediately.
A summary of U.S. laws governing Cisco cryptographic products may be found at:
http://www.cisco.com/wwl/export/crypto/tool/stqrg.html
If you require further assistance please contact us by sending email to
Cisco 2821 (revision 53.50) with 245760K/16384K bytes of memory.
Processor board ID FHK1205F0DL
2 Gigabit Ethernet interfaces
12 Serial interfaces
1 ATM interface
1 terminal line
2 Channelized E1/PRI ports
1 Virtual Private Network (VPN) Module
4 Voice FXS interfaces
1 cisco service engine(s)
DRAM configuration is 64 bits wide with parity enabled.
239K bytes of non-volatile configuration memory.
125440K bytes of ATA CompactFlash (Read/Write)
Configuration register is 0x2102
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: