Add Port to h323 Dial-peer

Unanswered Question
Jun 4th, 2008
User Badges:

Trying to add a new bri port to an existing h323 gw, which has 2 bri's already configured. When creating dial peer, I cannot select new bri port. do I need to reset the h323 in order to see the new port in dialpeer config? thanks

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Chris Deren Wed, 06/04/2008 - 08:59
User Badges:
  • Super Silver, 17500 points or more
  • Hall of Fame,
  • Cisco Designated VIP,

    2017 IP Telephony, Contact Center, Unified Communications

First of all is the card even detected? Does it show under "sh diag", second of all is there a voice-port in the configuration?


Chris

balitewiczp Wed, 06/04/2008 - 09:04
User Badges:

Shows up under show diag, and sho run.


voice port config is missing, cannot add 0/0/0


interface BRI0/0/0

no ip address

encapsulation hdlc

isdn switch-type basic-net3

isdn point-to-point-setup

isdn incoming-voice voice

isdn sending-complete

isdn static-tei 0


balitewiczp Wed, 06/04/2008 - 11:31
User Badges:

that looks like a global command. 2 BRI ports are already working. Is this an interface command? Also, tried removing the hdlc encap, keeps coming back.

Actions

This Discussion