cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
324
Views
0
Helpful
4
Replies

Add Port to h323 Dial-peer

balitewiczp
Level 2
Level 2

Trying to add a new bri port to an existing h323 gw, which has 2 bri's already configured. When creating dial peer, I cannot select new bri port. do I need to reset the h323 in order to see the new port in dialpeer config? thanks

4 Replies 4

Chris Deren
Hall of Fame
Hall of Fame

First of all is the card even detected? Does it show under "sh diag", second of all is there a voice-port in the configuration?

Chris

Shows up under show diag, and sho run.

voice port config is missing, cannot add 0/0/0

interface BRI0/0/0

no ip address

encapsulation hdlc

isdn switch-type basic-net3

isdn point-to-point-setup

isdn incoming-voice voice

isdn sending-complete

isdn static-tei 0

You may have been probably forgotten "isdn layer-1 emulate" and "isdn protocol-emulate network" commands.

Hope the following link helps...

http://www.cisco.com/en/US/docs/ios/12_1/12_1xi/feature/guide/dt_brint.html

And I surprised to see HDLC encapsulation on the interface.

Regards..

-Ashok.


With best regards...
Ashok

that looks like a global command. 2 BRI ports are already working. Is this an interface command? Also, tried removing the hdlc encap, keeps coming back.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: