06-04-2008 08:34 AM - edited 03-15-2019 11:03 AM
Trying to add a new bri port to an existing h323 gw, which has 2 bri's already configured. When creating dial peer, I cannot select new bri port. do I need to reset the h323 in order to see the new port in dialpeer config? thanks
06-04-2008 08:59 AM
First of all is the card even detected? Does it show under "sh diag", second of all is there a voice-port in the configuration?
Chris
06-04-2008 09:04 AM
Shows up under show diag, and sho run.
voice port config is missing, cannot add 0/0/0
interface BRI0/0/0
no ip address
encapsulation hdlc
isdn switch-type basic-net3
isdn point-to-point-setup
isdn incoming-voice voice
isdn sending-complete
isdn static-tei 0
06-04-2008 09:29 AM
You may have been probably forgotten "isdn layer-1 emulate" and "isdn protocol-emulate network" commands.
Hope the following link helps...
http://www.cisco.com/en/US/docs/ios/12_1/12_1xi/feature/guide/dt_brint.html
And I surprised to see HDLC encapsulation on the interface.
Regards..
-Ashok.
06-04-2008 11:31 AM
that looks like a global command. 2 BRI ports are already working. Is this an interface command? Also, tried removing the hdlc encap, keeps coming back.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: