No Heat Maps being displayed in WCS

Unanswered Question
Jun 4th, 2008
User Badges:

WCS 4.2.81.0

WLC 4.2.112.0

Loc 3.1.36.0


I have a very large map with currently 40 APs placed on it. Tt will have close to 80 when completed.


Layer that are on:

AP

AP Heatmaps

Clients

Rogue APs


Resaved AP placement and recalc RF prediction. Antennas are all set to other as the 1242 are being transmitted across a Mobile Access DAS.


I'm seeing clients and rogues, but no AP heat maps. Any ideas what is happening

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (2 ratings)
Loading.
Scott Fella Wed, 06/04/2008 - 15:33
User Badges:
  • Super Silver, 17500 points or more
  • Hall of Fame,

    The Hall of Fame designation is a lifetime achievement award based on significant overall achievements in the community. 

  • Cisco Designated VIP,

    2017 Wireless

In the layers under Access Points, you can only check 802.11a or 802.11b/g. If you have checked 802.11a + 802.11b/g then you will see no heat map.

twikel Fri, 06/06/2008 - 08:02
User Badges:

Fixed that and had to change AP Antennas to defualt rubber ducks. The 'Other' selection doesn't seem to have a radation pattern associated with it.


Thanks

Actions

This Discussion

 

 

Trending Topics: Other Wireless Mobility

client could not be authenticated
Network Analysis Module (NAM) Products
Cisco 6500 nam
reason 440 driver failure
Cisco password cracker
Cisco Wireless mode