06-04-2008 01:31 PM - edited 07-03-2021 03:59 PM
WCS 4.2.81.0
WLC 4.2.112.0
Loc 3.1.36.0
I have a very large map with currently 40 APs placed on it. Tt will have close to 80 when completed.
Layer that are on:
AP
AP Heatmaps
Clients
Rogue APs
Resaved AP placement and recalc RF prediction. Antennas are all set to other as the 1242 are being transmitted across a Mobile Access DAS.
I'm seeing clients and rogues, but no AP heat maps. Any ideas what is happening
06-04-2008 03:33 PM
In the layers under Access Points, you can only check 802.11a or 802.11b/g. If you have checked 802.11a + 802.11b/g then you will see no heat map.
06-06-2008 08:02 AM
Fixed that and had to change AP Antennas to defualt rubber ducks. The 'Other' selection doesn't seem to have a radation pattern associated with it.
Thanks
11-03-2009 08:14 AM
We just ran into this. we upgraded from WCS 4.2 to 5.2 and the default filters were all selected so we were not seeing the heatmaps. This was the solution for us.
Thanks
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide