1242 AP speed and duplex setting modifications

Unanswered Question

I have 3 AIR-LAP1242AG-A-K9 connected to a Cisco 4006 and the FCS,Xmit, and Rcv errors are quickly incrementing. The switch ports are set @ "auto/auto" for speed/duplex.


The WLC is running version 4.0.217.0, and I can't find a way to check/change the ap speed/duplex settings through a GUI or CLI.


Any ideas?


Thanks-William

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Scott Fella Wed, 06/04/2008 - 16:15
User Badges:
  • Super Silver, 17500 points or more
  • Hall of Fame,

    The Hall of Fame designation is a lifetime achievement award based on significant overall achievements in the community. 

  • Cisco Designated VIP,

    2017 Wireless

You can't change the port settings. You can try these debug commands and that might show you the interface. Have you tried to move the ap's to a different port.

Scott Fella Thu, 06/05/2008 - 07:52
User Badges:
  • Super Silver, 17500 points or more
  • Hall of Fame,

    The Hall of Fame designation is a lifetime achievement award based on significant overall achievements in the community. 

  • Cisco Designated VIP,

    2017 Wireless

Sorry..


debug ap enable ""

debug ap command "sh cont Dot11Radio1" ""

debug ap command "show interfaces dot11radio" ""

debug ap disable ""


What are the ports negotiating to?

Actions

This Discussion

 

 

Trending Topics: Other Wireless Mobility

client could not be authenticated
Network Analysis Module (NAM) Products
Cisco 6500 nam
reason 440 driver failure
Cisco password cracker
Cisco Wireless mode