cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
638
Views
0
Helpful
4
Replies

1242 AP speed and duplex setting modifications

william.weir
Level 1
Level 1

I have 3 AIR-LAP1242AG-A-K9 connected to a Cisco 4006 and the FCS,Xmit, and Rcv errors are quickly incrementing. The switch ports are set @ "auto/auto" for speed/duplex.

The WLC is running version 4.0.217.0, and I can't find a way to check/change the ap speed/duplex settings through a GUI or CLI.

Any ideas?

Thanks-William

4 Replies 4

Scott Fella
Hall of Fame
Hall of Fame

You can't change the port settings. You can try these debug commands and that might show you the interface. Have you tried to move the ap's to a different port.

-Scott
*** Please rate helpful posts ***

Which debug settings are you referring to?

No-these 3 AP's are on consecutive ports-hard to imagine all 3 are bad. Rest of environment is fine with same settings.

Sorry..

debug ap enable ""

debug ap command "sh cont Dot11Radio1" ""

debug ap command "show interfaces dot11radio" ""

debug ap disable ""

What are the ports negotiating to?

-Scott
*** Please rate helpful posts ***

Thank you.

a-100, a-Full

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: