1242 AP speed and duplex setting modifications

william.weir · ‎06-04-2008

I have 3 AIR-LAP1242AG-A-K9 connected to a Cisco 4006 and the FCS,Xmit, and Rcv errors are quickly incrementing. The switch ports are set @ "auto/auto" for speed/duplex.

The WLC is running version 4.0.217.0, and I can't find a way to check/change the ap speed/duplex settings through a GUI or CLI.

Any ideas?

Thanks-William

Scott Fella · ‎06-04-2008

You can't change the port settings. You can try these debug commands and that might show you the interface. Have you tried to move the ap's to a different port.

-Scott
*** Please rate helpful posts ***

william.weir · ‎06-05-2008

Which debug settings are you referring to?

No-these 3 AP's are on consecutive ports-hard to imagine all 3 are bad. Rest of environment is fine with same settings.

Scott Fella · ‎06-05-2008

Sorry..

debug ap enable ""

debug ap command "sh cont Dot11Radio1" ""

debug ap command "show interfaces dot11radio" ""

debug ap disable ""

What are the ports negotiating to?

-Scott
*** Please rate helpful posts ***

william.weir · ‎06-05-2008

Thank you.

a-100, a-Full