sure .... I see it... PVDM Slot 0:

8-channel (G.711) Voice/Fax PVDMII

8 channel- only going to support 8 of the 12..is that correct?

Slot 0:

C2811 Motherboard with 2FE and integrated VPN Port adapter, 2 ports

Port adapter is analyzed

Port adapter insertion time unknown

Onboard VPN : v2.2.0

EEPROM contents at hardware discovery:

PCB Serial Number : FOC12200YEC

Hardware Revision : 1.0

Top Assy. Part Number : 800-26920-04

Board Revision : A0

Deviation Number : 0

Fab Version : 04

RMA Test History : 00

RMA Number : 0-0-0-0

RMA History : 00

Processor type : 87

Hardware date code : 20080515

Chassis Serial Number : FTX1222A211

Chassis MAC Address : 001d.700b.fab8

MAC Address block size : 24

CLEI Code : COM7R00ARA

Product (FRU) Number : CISCO2811

Part Number : 73-10258-05

Version Identifier : V05

EEPROM format version 4

EEPROM contents (hex):

PVDM Slot 0:

8-channel (G.711) Voice/Fax PVDMII DSP SIMM PVDM daughter card

Hardware Revision : 4.0

Part Number : 73-8848-05

Board Revision : B0

Deviation Number : 0

Fab Version : 04

PCB Serial Number : FOC12133ESH

RMA Test History : 00

RMA Number : 0-0-0-0

RMA History : 00

Processor type : 00

Product (FRU) Number : PVDM2-8

Version Identifier : V01

EEPROM format version 4

EEPROM contents (hex):

WIC Slot 0:

FT1 PMC4351

Hardware Revision : 1.2

PCB Serial Number : FOC12175KAY

Part Number : 73-8346-05

Board Revision : A0

RMA Test History : 00

RMA Number : 0-0-0-0

RMA History : 00

Deviation Number : 0-0

Product (FRU) Number : WIC-1DSU-T1-V2

Top Assy. Part Number : 800-22193-03

CLEI Code : IPUIAPRRAA

EEPROM format version 4

EEPROM contents (hex):

Hi,

Considering that you have the following modules -

VIC2-4FXO [3Nos.]

VWIC2-1MFT-T1/E1 [T1]

You'll need total 3 DSPs.

one PVDM2-32 + one PVDM2-8

I guess you'll have to add one more PVDM.

One PVDM2-8 is capable of supporting 8 FXO interfaces and this is what is happening with you. So you need additional DSPs for the other voice interfaces to be detected.

Hope this clarifies.

-> Sushil

Many thanks..greatly appreciate the help..thanks agin for your time

Hi, I have a question regarding your answer here. Is there any way you could run a VIC2-4FXO without any DSP's? Like possible in software?

Hi Peter,

I don't think that's possible. Hardware DSPs would be required for the card to work.

I am not saying that what you mentioned is not at all possible, i would rather say that its not implemented in such a way on cisco routers.

HTH

-> Sushil