4507 with Redundant SUPS

Unanswered Question
Jun 5th, 2008
User Badges:

I get this message whenever I do a wr mem:


%HA_CONFIG_SYNC-3-IPC: cannot open standby port no such port

%C4K_REDUNDANCY-5-CONFIGSYNC: The startup-config has been successfully synchronized to the standby supervisor

%C4K_REDUNDANCY-5-CONFIGSYNC: The private-config has been successfully synchronized to the standby supervisor

%HA_CONFIG_SYNC-3-IPC: cannot open standby port no such port.


Any ideas what is going on? Redundancy Mode is set to RPR.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
gpulos Thu, 06/05/2008 - 08:44
User Badges:
  • Blue, 1500 points or more

The "%HA_CONFIG_SYNC-3-IPC: cannot open standby port no such port..." error is generated due to a configuration synchronization problem/error that occured.


The C4K lines are only informational stating that configuration synch did occur successfully.


Since the config sync did complete sucessfully, there should be no problem failing over to the standby if it is required. You should test this after hours to be sure.


(verify your IOS is the same version on both sups)


Todd Kelly Thu, 06/05/2008 - 09:03
User Badges:

Just found out the the IOS versions are different. Thats the problem.


Thanks.

Actions

This Discussion