Cisco 6500 series..netflow configuration

Unanswered Question
Jun 5th, 2008

In Cisco 6509, while setting the flow mask to interface-full mode I get the following error..

% Unable to configure flow mask for ip protocol: interface-full. Reset to the

default flow mask type: none

Is it a limitation?

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Jan Nejman Fri, 06/06/2008 - 02:38

Hello,

some features as NAT may require certain flow mask. Do you using some special features (NAT,IPSec,bridging)?

Please, could you send me your current flowmask. (show mls netflow flowmask)

or in better case the full configuration.

Kind regards,

Jan Nejman

Caligare, Co.

http://www.caligare.com/

linker.team Mon, 06/16/2008 - 22:12

Hi Jan,

Here are the outputs.

#sh mls netflow flowmask

current ip flowmask for unicast: null

current ipv6 flowmask for unicast: null

Also SUP 720 runs 12.2(18)SXF8 IOS.

Do you have any insights on this.

Thanks

Raj

Actions

This Discussion