Mobility Caller ID issue with UCM6.0.1 BE

Unanswered Question
Jun 5th, 2008
User Badges:

I've got about 10 users set up using Mobility with remote destination profiles pointing to their cell phones. My problem is that when they receive a mobility call, the caller ID is showing up as the main office number. We are masking all outbound calls using the main DID here, so I imagine that is where this is coming from.


How can I keep my outgoing calls using this mask, but also allow caller ID for Mobility calls? If this is not possible, what do I need to do to enable caller ID for Mobility?


Many thanks in advance.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
thisisshanky Thu, 06/05/2008 - 10:55
User Badges:
  • Purple, 4500 points or more

You can setup a separate CSS /partition that matches a separate route pattern for calls to go out from remote destination profiles. This CSS should be applied to the remote destination profile. The route pattern u create should not have caller id for outbound calls masked to the main DID.


Does this makes sense ?


Sankar


PS: please remember to rate posts!

Chris Driggers Thu, 06/05/2008 - 11:25
User Badges:

That does make perfect sense. I will implement this and let you know how it works!

brett.shaffer Thu, 07/10/2008 - 14:08
User Badges:

Will this also work under the following senario?

User is on CM A with ICT to CM B. All gateways are registered to CM B with external Mask.


How can I tell CM B that the call from CM A is a mobile connect call and doesn't need external mask vs a normal outbound call that does? Separate ICT's..one for normal calls and one for destination profiles?

Actions

This Discussion