Baseline Templates - Interface Configuration

Unanswered Question

We're checking compliance on all FA ports for switches using standard config settings:


+switchport mode access

+switchport access vlan xxx

+switchport port-security

etc.


However, sometimes an AP hangs off a FA port or even a switch and want to build some logic in to handle those interfaces. Doing [#(access|trunk)#] handles the trunk issue, but it seems like it should be if trunk then a different set of checks should be in place.


Can that be done in the templates?


TIA

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.

Actions

This Discussion