cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
635
Views
0
Helpful
3
Replies

Upgrade problem

acristofari
Level 1
Level 1

Hi,

I have a question about cisco asa upgrade.

I try to upgrade version 8.0.2 to 8.0.3 via rommon. The upgrade have success. When i reload the cisco asa i see the version 8.0.3 but into the flash i don't see the file. Could you help me?

3 Replies 3

husycisco
Level 7
Level 7

Hi alessandro,

Image installation or upgrade in rommon mode extracts the image to RAM and starts your startup config with the image for you to see if there are any inconsistencies. You should manually copy the new image to flash either in rommon or in priv mode after the extraction...

copy tftp://tftpserverip/8.0.3image.bin flash:image

Regards

Hi Sir

I have a question related to IOS for ASA. I have two IOS ver on ASA 7.2 and 8.03. Currently it use 7.2. If I tell ASA to use 8.03 which already in ASA, will it ask to reload ASA?

Thanks

Noom

Yes it will have to reload.

Regards

Farrukh

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: