cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
334
Views
0
Helpful
3
Replies

2960 Port Security

thestagman
Level 1
Level 1

Hi All

I'm having a bit of a dilema configuring some 2960 switch ports for port security.

Each Port must only see one legal device connected to it and shutdown should someone connect an illegal device.

I have configured the port accordingly. But if I have the switchport port-security max set to 1, nothing works and if I set it to, 2 everything works including illegal devices ..

I cannot see for the life of me whatI am doing wrong .. can any one advise ?

interface FastEthernet0/14

switchport access vlan 2

switchport mode access

switchport port-security

switchport port-security max 2

switchport port-security mac-address xxxx.xxxx.xxxx

speed 10

duplex full

spanning-tree portfast

spanning-tree bpduguard enable

3 Replies 3

Collin Clark
VIP Alumni
VIP Alumni

The default is 1 address, so I don't think you need the statement. Here's an example of ours.

switchport port-security

switchport port-security violation restrict

switchport port-security mac-address 0000.2222.4444

Hope that helps

Hello Collin

Thats worked a treat, I just removed the max setting and it all worked. Why I didn't think of that I just don't know ..

Thanks for your time

Mike

Glad it helped!

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: