CME 4.2 Meet-Me Conference issue

Unanswered Question
Jun 9th, 2008


I am in the process of setting up a meetme conference on a CME4.2 system, and despite following the admin guide and other guides referred to within other Netpro conversations, I just can't seem to get it to work.

Looking at the status of the dspfarm, the conference bridge appears to be in service, but if a user selects 'meetme' from their softkeys and dials the meetme ext (5194) they get a message on their phone advising 'no conference bridge'.

I've attached a copy of the running-config, and a capture of some show commands that might be of interest. Any help that could be offered would be greatly appreciated!



I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Paolo Bevilacqua Mon, 06/09/2008 - 04:54

Hi, you need to create more ephone-dn like the 35 you have already, up to the number of people that you want in conference, divided by two.

Also you need to so similarly for "ad-hoc" conferencing else once you set up "conference hardware", it will stop working.

Hope this helps, please rate post if it does!

gordonmarkus Mon, 06/09/2008 - 05:41


Thanks very much for the feedback. I've added some additional ephone-dn's now with the same number as ephone-dn 35. As soon as I have some feedback from the customer, I'll let you know whether it works.

Thanks again,


gordonmarkus Mon, 06/09/2008 - 06:43


Just to let you know that was it! It's all working now -thanks very much for your help.




This Discussion