remote span

Answered Question
Jun 9th, 2008
User Badges:

hello,

I have a 4507R Switch,and a 4 switchs 3550. i want configure a remote Span ( from some ports in each switchs to a unique port in the 4507R). could you help me with an example of configuration?!

many thanks

Hicham

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
Jagdeep Gambhir Mon, 06/09/2008 - 15:55
User Badges:
  • Red, 2250 points or more

Please see this link,


http://www.cisco.com/en/US/docs/switches/lan/catalyst4500/12.2/31sg/configuration/guide/span.html



Step 1.

Switch(config)# vlan 901

Switch(config-vlan)# remote span

Switch(config-vlan)# end


Step 2. Assuming gigabitethernet0/1 is the port that you want to sniff


Switch(config)# monitor session 1 source interface gigabitethernet0/1 both

Switch(config)# monitor session 1 destination remote vlan 901

Switch(config)# end


To get the information that is flowing to the remote VLAN (on our case 901), this needs to be done on the switch where you have the device that will receive the RSPAN traffic.


Step 3.

Switch(config)# vlan 901

Switch(config-vlan)# remote span

Switch(config-vlan)# end


Step 4. Assuming gig0/5 is the port where you have the PC/server with the shiff capture software.


Switch(config)# monitor session 1 source remote vlan 901

Switch(config)# monitor session 1 destination interface gig0/5

Switch(config)# end


All the switches on the path between initial switch and ending switch should have the remote VLAN, follow step 3 , also VTP pruning should be disable in order to allow the VLAN to be enabled and present on all the switches.



Regards,

~JG


Do rate helpful posts

chintan.shah Wed, 10/22/2008 - 07:40
User Badges:

Hi,


In Remote switch where device will received RSPAN traffic, if i have some source ports there to verify , can i have them in same session ?


Regards,

Chintan

Actions

This Discussion