port channelling on two MDS9513's

Unanswered Question
Jun 9th, 2008

Hi, I have two MDS9513's running SANOS 3.3. I have four ISL's between the switches but when i try and set up port channelling i get the message 'no ISL's available between MDS switches'. As yet the network is not live in our new data centre so i was wondering if SNMP is used at some point when setting up port channelling to identify switch type??? Enterprise license is installed on both switches.

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
jsivulka Mon, 06/16/2008 - 12:47

A couple of questions:

- What sort of line cards are you using?

- What VSAN's have you got configured?

- What zoning policy do you have and have you got any active zonesets on either switch?

- Have you setup switch priorities?

It is probably a defect identified as CSCsg27664.

Actions

This Discussion

 

 

Trending Topics: Storage Networking