Pix 515 VPN and traeroute and tunnel

Answered Question
Jun 10th, 2008
User Badges:

I have a FTP server called Ftptran sitting behind a PIX "interface general"

a. My network diagram

Traffic from the ftpserver should pass the pix to the VPN then the destination. I'm having problem with the tunnel , the problem is with my local host " Ftptran"

Trouble shoot

Either a ping or traceroute go past the server.

b. attached is the traceroute from the Ftptran.

fig 2.

Attached is my reduced Pix configuration


My ?. how can I configure the tracerout th pass the PIx interface and I need help



Correct Answer by smahbub about 8 years 11 months ago

"Traceroute" command (which can be known as tracert on a PC, trace or traceroute on Cisco IOS® Software, or traceroute on UNIX) can be used to troubleshoot connectivity. The traceroute command can operate differently based on the operating system of the source device.


Refer the section "Use the traceroute Command to Get to the PIX Interfaces" present in the following url which provides more information related to the issue:

http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_tech_note09186a00800e9312.shtml#topic3

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 3 (1 ratings)
Loading.
Correct Answer
smahbub Mon, 06/16/2008 - 13:12
User Badges:
  • Silver, 250 points or more

"Traceroute" command (which can be known as tracert on a PC, trace or traceroute on Cisco IOS® Software, or traceroute on UNIX) can be used to troubleshoot connectivity. The traceroute command can operate differently based on the operating system of the source device.


Refer the section "Use the traceroute Command to Get to the PIX Interfaces" present in the following url which provides more information related to the issue:

http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_tech_note09186a00800e9312.shtml#topic3

Actions

This Discussion