WLC with remote H-REAP AP and Web Auth

Unanswered Question


I'm currently configuring a WLC4402 with AP1130 in LWAPP. On the remote site, AP1130 are using H-REAP mode just to be sure we will not use the LWAPP tunnel to access the Internet. That part work fine.

After that, I want to use Web Authentication with a Radius Server and an Externnal Web authentication page. Radius is working fine and "Internal" Web page of the WLC works fine too. The problem I have is when I tried to forward the authentication to an External Web Page, it look like I'm stuck inside the LWAPP tunnel?!? I'm able to resolv Internet address because DNS is permit, but I didn't find a way to permit HTTP to a specific IP before the authentification is done.

Any idea?

Version of the WLC software: 5.0.148

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
aghaznavi Mon, 06/16/2008 - 12:44

debug lwapp events enable. This command provides information on the LWAPP events and errors that occur during the LWAPP discovery and join process for verification.


This Discussion



Trending Topics - Security & Network