cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
334
Views
0
Helpful
3
Replies

HSRP with no L2 connectivity

hodgem
Level 1
Level 1

Is this possible via pseudowire?

Alternatively two sites, both with internet connectivity - one deemed to be primary link the other failover. Sites also connected at L3 via a Service providers MPLS network.

What mechanism do I use to tell the site's network to use the failover link when the primary link fails?

3 Replies 3

richard.gosling
Level 1
Level 1

You can use weighted statics

As I pressed the submit button I recalled that as a possible solution.

However, I think I may have a requirement for a single published IP gateway address. Not sure how this would work though..

richard.gosling
Level 1
Level 1

What about BGP/EIGRP/IGRP and weighted static of the backup of 180

So when the primary link fails the protocol will drop and see the satic of 180 as the best route(backup router)

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: