06-11-2008 12:31 AM - edited 07-03-2021 04:00 PM
I can't find information about AIP-AP521 and AIP-AP1131 do they support 802.1p QoS and 802.11e Wireless QoS. I found one topic here: http://www.cisco.com/en/US/docs/wireless/access_point/350/configuration/guide/ap350ch1.html#wp1019578
but it is not clear is it related to all access point models, and how old is this topic. I need to be sure what model/models support this two standards, and is there some restrictions.
06-11-2008 04:24 AM
Both units will support QoS when controller based. As for autonomous, I have no clue as I try to only deploy LWAPP solutions today.
06-11-2008 05:31 AM
But I can't understand why here: http://www.cisco.com/en/US/docs/wireless/access_point/ios/release/notes/b41jarnh.html
as topic "Release Notes for Cisco Aironet Access Points for Cisco IOS Release 12.4(3g)JA" I read the following:
Some Client Devices Cannot Associate When QoS Is Configured
Some wireless client devices, including Dell Axim handhelds and Hewlett-Packard iPaq HX4700 handhelds, cannot associate to an access point when the access point is configured for QoS. To allow these clients to associate, disable QoS on the access point. You can use the QoS Policies page on the access point GUI to disable QoS, or enter this command on the CLI:
ap(config-if)#no dot11 qos mode
therefore, it is avaible command
#dot11 qos mode
The question is the same, about autonomous AP, is it support some kind of QoS ?
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: