Issue configuring controller E1 1/1 on E1/T1 PRI Card

Unanswered Question
Jun 11th, 2008
User Badges:

I'm trying to configure the second primary rate controller port, however this controller fails to connect successfully to the remote modem. It however successfully rings the telephone line. If I use the first primary rate port (controller E1 1/0) a connection to the remote modem is made successfully, every time. I've included attachments of the cisco debug and of the running set-up. Thus can anyone help please? since I beleive it must be a configuration issue.



  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
paolo bevilacqua Wed, 06/11/2008 - 13:58
User Badges:
  • Super Gold, 25000 points or more
  • Hall of Fame,

    Founding Member

Hi, can you try:

network-clock-select 2 E1 1/1


Note: never use debug all. Beside that it can crash the router, it's has too much info of no use.


hope this helps, please rate post if it does!

Actions

This Discussion