Port Counter Errors

kumarsri321 · ‎06-12-2008

Hi,

In my Network is having 6509-E and 4006 on IOS and catos.couple of the interfaces/ports on Full Duplex with speed auto.

Pointing out the issue is with port counter errors facing ---> Alignment,FCS and Input errors are increasing the count.

how can i rectify this errors.

Thanks in advance!

Mark Yeates · ‎06-12-2008

Typically the errors you are seeing are related to a bad cable, or NIC. Please check the cables and make sure they haven't been mangled, or crimped improperly.... etc

Here is a good troubleshooting guide.

http://www.cisco.com/en/US/products/hw/switches/ps700/products_tech_note09186a008015bfd6.shtml

Mark

kumarsri321 · ‎06-12-2008

Thanks a lot!! Mark

Drill down the list?

might correct the errors

glen.grant · ‎06-12-2008

Check on each end of the link on these , the settings must match , if the speed and duplex is auto on one end then it must be auto on the other end , if hardcoded to say 100/full then the other end must be hardcoded also . If you are attaching 2 cisco devices then auto/auto should work fine .