Add new E1 to old E1s to have same signal Channel .......???????????.......

Unanswered Question
Jun 12th, 2008

i need to add new E1 to be in the same trunk for previous E1 which is for Abdali. new E1 will not have signal it depeneds at old one.

i used this for new E1:

prov-add:nailedtrnk:name="1033",srcsvc="ss7p-jtc-abdali",dstsvc="naspath1-abdali",srcspan="ffff",dstspan="0",srctimeslot="33",dsttimeslot="33",spansize=31

for old one this:

prov-add:nailedtrnk:name="1002",srcsvc="ss7p-jtc-abdali",dstsvc="naspath1-abdali",srcspan="ffff",dstspan="0",srctimeslot="2",dsttimeslot="2",spansize=30

============================

at AS5400 i used to add new E1:

controller E1 7/2

framing NO-CRC4

pri-group timeslots 1-31 nfas_d primary nfas_int 1 nfas_group 0

Is this true or there are other commands i should use?

----------------------------

OLD E1 is configured as:

controller E1 7/0

framing NO-CRC4

channel-group 0 timeslots 1

pri-group timeslots 2-31 nfas_d primary nfas_int 0 nfas_group 0

description Connection to Abdali

interface Serial7/0:0

no ip address

encapsulation ss7

channel-id 0

!

interface Serial7/0:15

no ip address

encapsulation hdlc

isdn switch-type primary-ni2c

isdn incoming-voice modem

isdn map address . plan isdn type network

isdn rlm-group 0

no isdn send-status-enquiry

isdn negotiate-bchan resend-setup

isdn bchan-number-order ascending

no cdp enable

please see attached file for more details.

any help please?

Attachment: 
I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.

Actions

This Discussion