06-13-2008 06:26 AM
Hi
What is the following command impact on router ?
ip telnet source-interface Loopback0
thanks
Arun
06-13-2008 07:23 AM
Arun,
This command makes sure that any outbound telnet sessions are sourced using the loopback interface address.
If you do not configure this command, the routing table is looked up and the address of the outgoing interface towards the destination address is used as the source address for the telnet session. The fact that the source address is not always the same might be an issue when building and ACL.
Regards,
06-13-2008 09:06 PM
HI Arun, [Pls RATE all Informative POST]
Refer useful link below:
http://www.ciscopress.com/articles/article.asp?p=27137
The document explains the usage of Loopback0 Interface as SOURCE for various Router Management Activities [Includes ip telnet source-interface Loopback0 - explanantion]
Hope I am Informative.
Pls RATE all Informative POST
Best Regards,
Guru Prasad R
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: