UC500 outbound calls

Unanswered Question
Jun 13th, 2008
User Badges:
  • Green, 3000 points or more

I am attempting to use a single analog pots line in an FXO port for outgoing calls. The line is currently working for incoming calls just fine. Is is possible for this to work? If I dial "9" all I get is unknown number and a busy tone. Thanks.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 1 (1 ratings)
paolo bevilacqua Fri, 06/13/2008 - 06:42
User Badges:
  • Super Gold, 25000 points or more
  • Hall of Fame,

    Founding Member

Likely DP need proper configuration.

jbarcena Fri, 06/13/2008 - 07:26
User Badges:
  • Red, 2250 points or more

As already noted seems to be a problem with your config. why don't you post the show run and we can go from there

acomiskey Fri, 06/13/2008 - 08:10
User Badges:
  • Green, 3000 points or more

Thanks guys. I added "port 0/1/1" and have the following. It is now working outbound.

dial-peer voice 51 pots

corlist outgoing call-domestic

description ** FXO pots dial-peer **

translation-profile outgoing CALLER_ID_TRANSLATION_PROFILE

preference 5

destination-pattern 91[2-9]..[2-9]......

port 0/1/1

prefix 1

no sip-register

I have a lot to learn.


This Discussion