Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
334
Views
1
Helpful
3
Replies

UC500 outbound calls

acomiskey
Level 10
Level 10

‎06-13-2008 06:40 AM - edited ‎03-15-2019 11:15 AM

I am attempting to use a single analog pots line in an FXO port for outgoing calls. The line is currently working for incoming calls just fine. Is is possible for this to work? If I dial "9" all I get is unknown number and a busy tone. Thanks.

Labels:
0 Helpful
3 Replies 3

paolo bevilacqua
Hall of Fame
Hall of Fame

‎06-13-2008 06:42 AM

Likely DP need proper configuration.

0 Helpful

jbarcena
Level 9
Level 9

‎06-13-2008 07:26 AM

As already noted seems to be a problem with your config. why don't you post the show run and we can go from there

acomiskey
Level 10
Level 10
In response to jbarcena

‎06-13-2008 08:10 AM

Thanks guys. I added "port 0/1/1" and have the following. It is now working outbound.

dial-peer voice 51 pots

corlist outgoing call-domestic

description ** FXO pots dial-peer **

translation-profile outgoing CALLER_ID_TRANSLATION_PROFILE

preference 5

destination-pattern 91[2-9]..[2-9]......

port 0/1/1

prefix 1

no sip-register

I have a lot to learn.

0 Helpful
Customers Also Viewed These Support Documents