cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
407
Views
0
Helpful
1
Replies

Bridge Protocol Options

j-griffin
Level 1
Level 1

I am replacing some 4908G L3 switches with some 3750G L3 switches and am having a problem with the bridge protocol command. On the 4908s I have the following commands…

bridge 1 protocol ieee

bridge 1 route ip

bridge 1 priority 100

However on the 3750G L3 switch with 12.2.25 SEB4 Enhanced Multilayer Image software

I don't have an option for “bridge 1 protocol ieee”, I only have the option for protocols dec,ibm or vlan-bridge.

How can I configure the bridge protocol to support ieee?

1 Reply 1

didyap
Level 6
Level 6

IOS running on the 3750G L3 switch with 12.2.25 SEB4 Enhanced Multilayer Image software does not support the IEEE bridging protocol for bridge groups, Meaning ieee is not supported for bridge groups running IOS. You should configure bridge groups to use VLAN-bridge or DEC protocol spanning tree.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco