06-13-2008 04:56 PM - edited 03-05-2019 11:37 PM
I have a 3750 that I'm using as a router:
"ip routing"
..and "no switchport" on the routing interfaces.
I added "ip accounting output-packets"
on both the interfaces setup for routing and ran a bunch of traffic through the device. But "show ip accounting" gives me nothing.
This seemed to work so easily on my 2821 router. Is there something about this being a switch that messes with accounting? Is there an alternative? Thanks!
Solved! Go to Solution.
06-13-2008 05:04 PM
Sorry, ip accounting is not supported under Catalyst switches.
HTH,
__
Edison
Please rate helpful posts
06-13-2008 05:04 PM
Sorry, ip accounting is not supported under Catalyst switches.
HTH,
__
Edison
Please rate helpful posts
06-13-2008 05:06 PM
Thanks for the reply!
Too bad they can't remove unsupported commands.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: