PGW reboot for machine and services ..............?????????????...........

Answered Question
Jun 15th, 2008

Hello,

any body can tell me how can:

1. Reboot PGW as machine (Totally reboot)

2. Service rebbot only

please can show the commands and steps.

thank you for any help.

I have this problem too.
0 votes
Correct Answer by scpage about 8 years 5 months ago

1) /etc/init.d/CiscoMGC stop

reboot

2) /etc/init.d/CiscoMGC stop

/etc/init.d/CiscoMGC start

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
Correct Answer
scpage Mon, 06/16/2008 - 12:28

1) /etc/init.d/CiscoMGC stop

reboot

2) /etc/init.d/CiscoMGC stop

/etc/init.d/CiscoMGC start

tareqrebhi Tue, 06/17/2008 - 01:13

ok thank you.

i have now this issue:

i need to add new E1 to be in the same trunk for previous E1 which is for Abdali. new E1 will not have signal it depeneds at old one timeslot.

i used this for new E1:

prov-add:nailedtrnk:name="1033",srcsvc="ss7p-jtc-abdali",dstsvc="naspath1-abdali",srcspan="ffff",dstspan="0",srctimeslot="33",dsttimeslot="33",spansize=31

for old one this:

prov-add:nailedtrnk:name="1002",srcsvc="ss7p-jtc-abdali",dstsvc="naspath1-abdali",srcspan="ffff",dstspan="0",srctimeslot="2",dsttimeslot="2",spansize=30

============================

at AS5400 i used to add new E1:

controller E1 7/2

framing NO-CRC4

pri-group timeslots 1-31 nfas_d primary nfas_int 1 nfas_group 0

Is this true or there are other commands i should use?

----------------------------

OLD E1 is configured as:

controller E1 7/0

framing NO-CRC4

channel-group 0 timeslots 1

pri-group timeslots 2-31 nfas_d primary nfas_int 0 nfas_group 0

description Connection to Abdali

interface Serial7/0:0

no ip address

encapsulation ss7

channel-id 0

!

interface Serial7/0:15

no ip address

encapsulation hdlc

isdn switch-type primary-ni2c

isdn incoming-voice modem

isdn map address . plan isdn type network

isdn rlm-group 0

no isdn send-status-enquiry

isdn negotiate-bchan resend-setup

isdn bchan-number-order ascending

no cdp enable

any help please for correct commands i shall use? please see attached file for details

Attachment: 

Actions

This Discussion