Hello,
I am installing a new AS5400 and using DPNSS from the E1 connection.
I am experiencing an error in the MG Debug Q921 such as: PBXa RX <- UNKNOWN dlic=0 . Is this a problem from the SP side? Or MG side?
I have the following:
ISDN Serial6/4:15 interface
dsl 2, interface ISDN Switchtype = primary-dpnss
L2 Protocol = Q.921 0x0000 L3 Protocol(s) = IUA BACKHAUL 0x0002
Layer2 status:
Channel 1 : OUT OF SERVICE
interface Serial6/4:15
no ip address
encapsulation hdlc
isdn switch-type primary-dpnss
isdn bind-l3 iua-backhaul as-mg
isdn dpnss pbxA
no cdp enable
Thank you and best regards,
Bruno Nunes.