×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

CatOS port statistics

Answered Question
Jun 16th, 2008
User Badges:

Hello all,


I'm after, if it exists, a CatOS command that replicates the 'show interface' which displays the tx and rx load on a port, be it x/255 or y% (as per the sho int command in IOS).

Thanks

Bernie

Correct Answer by andrew.burns about 9 years 2 months ago

Hi,


there's no exact equivalent but "show mac utilization" should give you what you need. Might also be worth reading the command reference to see how it's calculated.


HTH

Andrew.


  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
Correct Answer
andrew.burns Mon, 06/16/2008 - 04:45
User Badges:
  • Gold, 750 points or more

Hi,


there's no exact equivalent but "show mac utilization" should give you what you need. Might also be worth reading the command reference to see how it's calculated.


HTH

Andrew.


Actions

This Discussion