06-16-2008 03:25 AM - edited 03-05-2019 11:39 PM
Hello all,
I'm after, if it exists, a CatOS command that replicates the 'show interface' which displays the tx and rx load on a port, be it x/255 or y% (as per the sho int command in IOS).
Thanks
Bernie
Solved! Go to Solution.
06-16-2008 04:45 AM
Hi,
there's no exact equivalent but "show mac utilization" should give you what you need. Might also be worth reading the command reference to see how it's calculated.
HTH
Andrew.
06-16-2008 04:45 AM
Hi,
there's no exact equivalent but "show mac utilization" should give you what you need. Might also be worth reading the command reference to see how it's calculated.
HTH
Andrew.
06-16-2008 05:08 AM
Thanks Andrew.
Just the command that I needed.
Bernie
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: