06-16-2008 06:13 AM - edited 03-15-2019 11:18 AM
Hi,
Unable to see voice-port command in 3845 router.
PVDM2-64 modules have been installed and displayed in "sh diag"
NM-1CE1T1-PRI has been configured and the "isdn status" is also up.
Any suggestions..
06-16-2008 06:15 AM
HI friend,
Did you saw this link?, may be helpful.
Notice the card type command.
http://www.cisco.com/en/US/docs/ios/12_3/feature/guide/gt_et2sw.html
Regards,
- adrián.
06-16-2008 06:24 AM
Hi, you cannot use NM-1CE1T1-PRI for voice, that is a data only card.
You need a VWIC or VWIC2 card for voice PRI on an ISR router.
Hope this helps, please rate post if it does!
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide
Log in to Community
