How to get serial number with command (show diag not working)

Answered Question
Jun 16th, 2008

Folks, I need to get serial number from remote 6509.

I tried 'show diag' but no output returned.

This is IOS version 12.2(18).

I have this problem too.
0 votes
Correct Answer by foxbatreco about 8 years 7 months ago

Sh ver command should work with 6509 to view the serial no.

U can find it appended with Process Board ID.

Pls rate/mark if this helps!!!

Correct Answer by otzispadmin about 8 years 7 months ago

Does sh ver work? The processor board id is the s/n.

Correct Answer by Collin Clark about 8 years 7 months ago

Try show inventory

Hope that helps

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (3 ratings)
Loading.
Correct Answer
otzispadmin Mon, 06/16/2008 - 09:13

Does sh ver work? The processor board id is the s/n.

Correct Answer
foxbatreco Mon, 06/16/2008 - 10:24

Sh ver command should work with 6509 to view the serial no.

U can find it appended with Process Board ID.

Pls rate/mark if this helps!!!

news2010a Mon, 06/16/2008 - 10:41

True. I did not realize that "processor board" is the same than "SN"!

Thanks all!!!

hsitar007 Tue, 06/17/2008 - 05:46

'Show module' would be the appropriate command on a 6509. It would even provide the card serial number along with the chassis serial number.

HTH

Ratish

h.parsons Tue, 06/17/2008 - 11:55

I use "show idprom backplane" if you are looking for the chassis SN. If not the there are other options after "show idprom ________"

Actions

This Discussion