cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
25446
Views
15
Helpful
7
Replies

How to get serial number with command (show diag not working)

news2010a
Level 3
Level 3

Folks, I need to get serial number from remote 6509.

I tried 'show diag' but no output returned.

This is IOS version 12.2(18).

3 Accepted Solutions

Accepted Solutions

Collin Clark
VIP Alumni
VIP Alumni

Try show inventory

Hope that helps

View solution in original post

otzispadmin
Level 1
Level 1

Does sh ver work? The processor board id is the s/n.

View solution in original post

foxbatreco
Level 3
Level 3

Sh ver command should work with 6509 to view the serial no.

U can find it appended with Process Board ID.

Pls rate/mark if this helps!!!

View solution in original post

7 Replies 7

Collin Clark
VIP Alumni
VIP Alumni

Try show inventory

Hope that helps

otzispadmin
Level 1
Level 1

Does sh ver work? The processor board id is the s/n.

foxbatreco
Level 3
Level 3

Sh ver command should work with 6509 to view the serial no.

U can find it appended with Process Board ID.

Pls rate/mark if this helps!!!

True. I did not realize that "processor board" is the same than "SN"!

Thanks all!!!

"processor board" is NOT  the same as "SN"

 

hsitar007
Level 1
Level 1

'Show module' would be the appropriate command on a 6509. It would even provide the card serial number along with the chassis serial number.

HTH

Ratish

h.parsons
Level 3
Level 3

I use "show idprom backplane" if you are looking for the chassis SN. If not the there are other options after "show idprom ________"

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco