the DOH is a low level DB editor that is designed for technicians and support personnel when troubleshooting unity.

DOHPropTest ("DPT")

http://www.cisco.com/en/US/products/sw/voicesw/ps2237/products_tech_note09186a00801ba0ef.shtml#yyy

Complete these steps for the DOHPropTest (DPT).

1.

Open a command line, and change (cd) to the Cisco Unity installation (typically C:\CommServer).

2.

Enter techtools\dohproptest.

3.

You are prompted for a password. Leave it blank, and clickOK.

4.

Click ignore.

You are now in read-only mode. For troubleshooting purposes, you can use the DPT utility in read-only mode. If further troubleshooting is necessary with this utility, create a case with Cisco TAC.

HTH

javalenc

if this helps, please rate