I have a network with 3 VLANs 192.168.72.X (Native), 192.168.100.X (Voice), 200.15.110.X (Data). Voice is based on CME running on a 2851 router. I have one WLC 2106 and 5 AP 1242. There are 6 switches Catalyst 520. I can't find what I'm doing wrong; although I have the voice running with several 7921 phones, they are being registered through native Vlan (192.168.72.X), while the Data WLAN (200) does not provide IP addresses. A ping from WLC to router is unsucessful.
Currently I have only the first port in the WLC attached to a switch port which is defined with Role : Other, Access VLAN 1. I had read several documents, I am not clear about the proper setup for all the devices involved. Attached is my WLC configuration.
Thanks in advance
Jerome and Daniel,
Are you both aware that you can get to the CLI on a 520. I have one at home. Use the command below to access the cli and then config the ports as you wish.
I had to configure my ports for trunking as well in my lab.