Solved: Extended IP access list for NAT

haa33110 · ‎06-17-2008

Hi, all.

Give me informations on access list for NAT.

Cisco IOS Master Command List, Release 12.4 describes the ip nat inside destination command, the ip nat inside source command, and the ip nat outside source command use standerd IP access list for dynamic NAT.

But the document follws uses extended IP access list for dynamic NAT in Difference between One-to-One Mapping and Many-to-Many section.

They leave me in confusion.

Regards

Pravin Phadte · ‎06-17-2008

Hi,

Not specific to 12.4 but the below link will help for nat.

http://www.cisco.com/en/US/tech/tk648/tk361/tk438/tsd_technology_support_sub-protocol_home.html

Regards,

Pravin

View solution in original post

haa33110 · ‎06-17-2008

>But the document follws uses extended IP access list for dynamic NAT in Difference between One-to-One Mapping and Many-to-Many section.

Hyperlinking slipped my mind.

http://www.cisco.com/en/US/tech/tk648/tk361/technologies_tech_note09186a0080094e77.shtml

Regards

Pravin Phadte · ‎06-17-2008

Hi,

Not specific to 12.4 but the below link will help for nat.

http://www.cisco.com/en/US/tech/tk648/tk361/tk438/tsd_technology_support_sub-protocol_home.html

Regards,

Pravin

haa33110 · ‎06-19-2008

Thanks for your advice.

Regards,

haa33110