×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.
Rick Morris Tue, 06/17/2008 - 06:36
User Badges:
  • Silver, 250 points or more

If a call needs to connect to a CCME at a different location it must be built and the TFTP server must be from that location.


For instance our HQ office, we also needed to open the IP for the phone in the firewall to allow traffic to flow, calls to process.


What will happen is the IP address from that location will be given to that device so it will be on the same subnet at that point.

paolo bevilacqua Tue, 06/17/2008 - 06:36
User Badges:
  • Super Gold, 25000 points or more
  • Hall of Fame,

    Founding Member

Yes, there is no problem in doing that. Only, you want to properly setup your routing so that any subnet where are phones, can communicate with all the others. If you cannot do that, configure "mtp" under the remote ephone.


Hope this helps, please rate post if it does!

laposilaszlo Tue, 06/17/2008 - 07:13
User Badges:

There are some special requiremens for this to work on a public internet VPN.

I heard that the round trip time must be under certain value.


Thak you again,

laszlo

paolo bevilacqua Tue, 06/17/2008 - 07:58
User Badges:
  • Super Gold, 25000 points or more
  • Hall of Fame,

    Founding Member

Hi, I have sites with RTT of like 900 ms (vsat) and they work just fine.


Thanks for the appreciation and good luck!

Actions

This Discussion