call notification second line ccm4.2

Answered Question
Jun 17th, 2008
User Badges:

Dear all,


I have a 7961 setup with 2 separate lines. if the person is using the first line and recieves a call on the second line, the person only hears one beep and the phone button is blinking.


is there a way that you can hear a beep like every 10 seconds?


regards,


Gerard

Correct Answer by chris.fortner about 9 years 1 month ago

You can change the incoming call alerting on the line page to say ring, beep, etc... I would check there and see if any of those work for you!

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
Rob Huffman Tue, 06/17/2008 - 06:21
User Badges:
  • Super Red, 40000 points or more
  • Hall of Fame,

    Founding Member

  • Cisco Designated VIP,

    2017 IP Telephony, Unified Communications

Hi Gerard,


Sadly there is no way to change this behaviour :( Have you changed the Device setting "Auto Line Select" to enabled so the user gets the new call screen display?


Hope this helps!

Rob

Correct Answer
chris.fortner Tue, 06/17/2008 - 11:11
User Badges:

You can change the incoming call alerting on the line page to say ring, beep, etc... I would check there and see if any of those work for you!

gerard van rij Wed, 06/18/2008 - 01:39
User Badges:

thanks Chris,


although I would prefer to have a beep which would repeat itself every x seconds. I've selected that the phone will ring if someone calls.


so.. it solved my problem.. thanks

Actions

This Discussion