4402 Network Routes

Unanswered Question
Jun 17th, 2008
User Badges:

I am having a tough time with setting up the "Network Routes" on our 4402. I am trying to add our ohter subnets but I get the "gateway needs to be on the service port" message?


My Service Port interface is on a dot 3 so why when I add a dot 8 to the "Network Routes" would I put a dot 3 as the Gateway IP Address? the gatewy should be dot 8.


I also noticed that the Service Port is optional, perhaps I will not configure this for now?

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
ericgarnel Tue, 06/17/2008 - 11:55
User Badges:
  • Gold, 750 points or more

Perhaps it is because that the management and dynamic ports are actually on a switchport that it itself does not "understand" routing. You are basically trying to tell the controller to use the same physical interface for trunking and routing.

whitefalcon6 Tue, 06/17/2008 - 12:11
User Badges:

What i'm saying is if I add a dot 8 to the network routes the gateway HAS to be dot 8, not a dot 3 just because that is the subnet that the service-port is on.


How do I get around this?



ericgarnel Thu, 06/19/2008 - 05:48
User Badges:
  • Gold, 750 points or more

You may need to implement router(s) between the two in order to make the route tables meet your needs.


Actions

This Discussion

 

 

Trending Topics - Security & Network