Device not reachable using telnet from LMS

Answered Question
Jun 17th, 2008
User Badges:

Hi,


I'm trying to add a device to the DCR. We can access it using telnet but when LMS 3.0.1 says it's not reachable.


If I launch a "Management Station to Device" it says telnet OK. If we launch "Check device credentials" it says "Device not reachable" using telnet and we have insert the credentials several times so it's impossible to insert them wrongly.


What can be happening?


Thanks.

Correct Answer by Joe Clarke about 9 years 1 month ago

Have you entered correct SNMP credentials for this device so that RME can properly manage it, and determine the correct device package to use?

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
Correct Answer
Joe Clarke Tue, 06/17/2008 - 14:29
User Badges:
  • Cisco Employee,
  • Hall of Fame,

    Founding Member

Have you entered correct SNMP credentials for this device so that RME can properly manage it, and determine the correct device package to use?

cmartinvalle Thu, 06/19/2008 - 01:16
User Badges:

Thank you very much.

The device did not haver configured SNMP. I thought devices could be managed also using telnet enable password.

Regards.

Actions

This Discussion