Duplex mismatch change does not reflect in sh interface type command

Unanswered Question
Jun 17th, 2008
User Badges:

I changed the Duplex setting on an Interface in a Switch to full . the startup and running config reflect the change from half to full, but the Show interface command still shows it as half. Why is it so ?

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
spremkumar Tue, 06/17/2008 - 22:25
User Badges:
  • Red, 2250 points or more

hi


In which switch model you are trying to change the same ?


Whats the os version currently running in the switch ?


can you post the output of show run/startup as well as show interface commands here ?


regds


glen.grant Wed, 06/18/2008 - 04:12
User Badges:
  • Purple, 4500 points or more

Did you hardcode the speed also ? Post a "show interface status" here so we can take a look at it. You could also bounce the port and see if it changes.

Actions

This Discussion