06-17-2008 09:41 PM - edited 03-05-2019 11:41 PM
I changed the Duplex setting on an Interface in a Switch to full . the startup and running config reflect the change from half to full, but the Show interface command still shows it as half. Why is it so ?
06-17-2008 10:25 PM
hi
In which switch model you are trying to change the same ?
Whats the os version currently running in the switch ?
can you post the output of show run/startup as well as show interface commands here ?
regds
06-18-2008 04:12 AM
Did you hardcode the speed also ? Post a "show interface status" here so we can take a look at it. You could also bounce the port and see if it changes.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide