06-18-2008 03:39 AM - edited 03-03-2019 10:24 PM
Hi,
Does anyone know of a command that will allow me to check if 1 of the 2 PSU's is faulty? I have an ongoing fault at the moment where 1 PSU is plugged into Comms Cabinet 1 which is fine but the 2nd PSU is plugged into a comms cabinet where the power is suspect. The command show environment all just shows that power is restored but I am looking for legacy information on the PSU.
Regards
Mary
06-18-2008 03:42 AM
Hi,
try show environment all
Hope this helps,
Regards
Pravin
06-18-2008 06:30 AM
Hello Mary,
if you want to see what happened before you may check the logging buffer with sh log.
To verify if the PSU is working correctly you should connect it to a power source you know it is working fine.
the PSU should have some LEDs on them to signal if they are on (green) or faulty.
hope to help
Giuseppe
06-18-2008 06:34 AM
Giuseppe
Nothing in log file and I am in a remote location so can't check PSU lights. I am surprised that there is no command to see if the PSU ever failed (nothing ever in logfile /environment log). Anyway, never mind, I give up!
Regards
mMary
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide